Power Button Actuator - HP ENVY x360 13 Maintenance And Service Manual

Power button actuator

Description
In ceramic white finish
In nightfall black finish
Before removing the power button actuator, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
a. Battery (see
b. Solid-state drive (see
c. System board (see
Remove the power button actuator:
1. Release the power button actuator spring arms (1) from the retention tabs (2) built into the keyboard/
top cover.
2. Remove the power button actuator (3).
3. Remove the power button actuator.
Reverse this procedure to install the power button actuator.
48 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 29)
Battery on page
System board on page
28), and then remove the following components:
29)
42)
Spare part number
L57885-001
L53437-001