Output 5/6 Screen; Output 6/6 Screen - Panasonic AW-UE150WP Operating Instructions Manual

Camera menu items (continued)

Output 5/6 screen

O u t p u t 5 /6
O S D O f f Wit h R- Tally
O S D S t a t us
T a l l y
T a l l y B r igh tnes s
S t a t u s L amp
E x t e r n a l Ou tput
O u t p u t 1
O u t p u t 2
R e t u r n
OSD Off With R‑Tally [Off, On]
Off or on the function that turns off camera menu, status, and other
displays when red tally signals are received via commands or
contacts.
When the red tally signal releases, the camera menu display will
return.
OSD Status [Off, On]
Turn the status display during AWB and ABB off/on, or error display
when an error occurs.
Tally
[Enable, Disable]
[Disable] or [Enable] is set here for the function which turns on or
turns off the tally lamp using the tally control signal.
Tally Brightness [Low, Mid, High]
Adjust the brightness of the tally LED.
Status Lamp
[Enable, Disable]
[Disable] or [Enable] is set here for the status display lamp.
When you want the status display lamp to stay off while this unit is in
operation, set to [Disable].
<NOTE>
• Even when set to [Disable], the status display lamp may light
up when this unit is starting up, updating firmware, or trouble is
occurring.
External Output
Select the signal type output from the External Output signal lines
(Output1, Output2) of the RS‑422 connector. (→ page 16)
Output1 [Off, R‑Tally, G‑Tally]
Output2 [Off, R‑Tally, G‑Tally]
Off Signal is not output.
R-Tally The reception status of the red tally signal is output.
G-Tally The reception status of the green tally signal is output.
Return
Return to the previous menu level.

Output 6/6 screen

Off
Off
Enable
Low
Enable
Off
Off
UHD Crop [Off, On]
Switch off/on the crop function which crops UHD (3840 × 2160)
images to FHD (1920 × 1080) images.
This is enabled only when [Format] in [System] screen is the
following.
2160/59.94p, 2160/29.97p
2160/50p, 2160/25p
2160/24p, 2160/23.98p
<NOTE>
• When [UHD Crop] is changed, IP video transmission is temporarily
stopped.
• [H.264(UHD)], [H.265(UHD)], and [JPEG(UHD)] cannot be selected
in [Streaming mode] when [UHD Crop] is [On]. (→ page 93)
When [H.264(UHD)], [H.265(UHD)], or [JPEG(UHD)] is selected in
[Streaming mode] and [UHD Crop] is switched from [Off] to [On], the
[Streaming mode] setting changes to [H.264].
3G SDI Out [Full, Crop]
IP Out [Full, Crop]
Make the settings for Full/Crop for images output to the 3G SDI OUT
connector and IP.
Full
Crop
This is only enabled when [UHD Crop] is set to [On].
Crop Out [YL, G, MG]
Make the settings for the crop frame for images output to the 3G SDI
OUT connector and IP.
YL
G
MG
This is only enabled when [UHD Crop] is set to [On].
<NOTE>
• The color frame specified in [Crop Out] will be a deeper shade when
compared to other colors used for frames.
60
O u t p u t 6 / 6
U H D C r o p
3 G S D I O u t
I P O u t
C r o p O u t
C r o p M a r k e r
C r o p A d j u s t
C r o p H P o s i t i o n
C r o p V P o s i t i o n
R e t u r n
FHD down-converted images are output as is without
cropping UHD images.
Images with FHD cropped from UHD images are
output.
The images output in this case are those with the crop
frame specified in [Crop Out].
Output the yellow crop frame images.
Output the green crop frame images.
Output the magenta crop frame images.
O f f
C r o p
C r o p
Y L
Y L + G + M G
Y L
9 6 0
5 4 0