What To Do When Encountering Problems In The Basic Shooting Operations - Panasonic AW-UE150WP Operating Instructions Manual

What to do when encountering problems in the basic shooting operations

If the trouble is not resolved by taking the action suggested below, refer
to "Troubleshooting" (→ page 139).
When performing operations from a wireless
remote control
The unit does not move.
• Press the <CAM1>, <CAM2>, <CAM3> or <CAM4> button to select
the unit which is to be operated.
If only one unit is being used, it is normally selected using the <CAM1>
button.
• Check that the IR ID switches have been set correctly. (→ page 17,
page 24)
• If the unit's status display lamp is off or lights up orange, it means that
the unit's power is not on.
Refer to "Turning the power on" (→ page 28), and turn on the power.
• If the unit's status display lamp does not blink even when the wireless
remote control is operated near the unit's wireless remote control
signal light-sensing area, it means that the wireless remote control's
batteries have run down.
Replace the batteries.
Multiple color bands (color bars) are displayed.
Switch to the camera image by pressing the <MODE> button.
The menu screen is displayed.
Press the <MENU> button for 2 seconds to exit the camera menu.
The lens focus is not adjusted automatically.
Press the <A/FOCUS> button to switch to auto focusing.
The camera picture is too light or too dark.
• Press the <A/IRIS> button to switch the lens iris adjustment to auto.
• Press the <AUTO> button of <GAIN> to switch the gain adjustment to
auto.
Something is wrong with the coloring of the camera
pictures.
Refer to "Auto tracking white adjustment (ATW)" (→ page 37), and
switch to [ATW].
The camera menus are not displayed.
Restart the camera and open any of the camera menus within about a
minute, the menus will be displayed in all the outputs.
Check [OSD Mix] (→ page 59) on the camera menu [Output 4/6]
screen.
When performing operations from a controller
The unit does not move.
• Select the unit to be operated by following the procedure below.
When using an AW‑RP150
For details, refer to the operating instructions for the controller.
• If the unit's status display lamp is off or lights up orange, it means that
the unit's power is not on.
Refer to "Turning the power on" (→ page 28), and turn on the power.
• Check that the account settings for this unit have been set correctly.
(→ page 76)
• Network connection with AW-RP150 requires setup of an initial
account. (→ page 26)
When an initial account is not set up, AW-RP150 can detect but
cannot control this unit.
Multiple color bands (color bars) are displayed.
Switch to the camera image by pressing the <BARS> button.
The lens focus is not adjusted automatically.
Press the <AUTO> button of <FOCUS> to switch to auto focusing.
The camera picture is too light or too dark.
• Press the <AUTO> button of <IRIS> to switch the lens iris adjustment
to auto.
• Press the <AUTO> button of <GAIN> to switch the gain adjustment to
auto.
Something is wrong with the coloring of the camera
pictures.
Refer to "Auto tracking white adjustment (ATW)" (→ page 37), and
switch to [ATW].
The camera menus are not displayed.
Restart the camera and open any of the camera menus within about a
minute, the menus will be displayed in all the outputs.
Check [OSD Mix] (→ page 59) on the camera menu [Output 4/6]
screen.
32