Panasonic AW-UE150WP Operating Instructions Manual page 114

Web screen configurations (continued)
Host authentication screen [Host auth.]
„ „
Click the [Host auth.] of User management screen [User mng.].
Configure the host authentication settings that restrict the personal
computers (IP addresses) that can access the unit.
z Setting status
„
Host auth.
The host authentication settings are displayed.
Host IP address
The host IP address is displayed.
Access level
The host access level is displayed.
z Mode.
„
Host auth. [Off, On]
Host authentication is set to [On] or [Off] here.
The setting is confirmed with the [Set] button.
Factory settings: Off
z Add host.
„
IP address
The IP address of the personal computer from which access to the
camera is allowed is input here. The host name cannot be input as
the IP address.
<NOTE>
• When the "IP address/subnet mask length" is input, the personal
computers which are allowed to access the camera can be
restricted on a subnet by subnet basis.
If, for instance, "192.168.0.1/24" has been input and the [2. Camera
control] setting has been selected as the [Access level] setting, the
personal computers from "192.168.0.1" to "192.168.0.254" will be
able to access the camera at the [2. Camera control] access level.
• When an already registered IP address is input and the [Set] button
is clicked, the host information will be overwritten.
Access level [1.Administrator, 2.Camera control]
Select the host access level.
The setting is confirmed with the [Set] button.
1.Administrator This access level allows the user to perform all the
unit's operations.
2.Camera control This access level allows you to display images and
control the unit. The unit cannot be set.
Factory settings: 2.Camera control
z Delete host.
„
Delete the host information registered in the unit.
You can delete selected host information by clicking the [Delete] button
at the right.
114