Black Level (Master Pedestal) Adjustment - Panasonic AW-UE150WP Operating Instructions Manual

Black level (master pedestal) adjustment

The black level can be adjusted when using a multiple number of
cameras including the unit. Ask your dealer to perform this adjustment.
(Use an oscilloscope or waveform monitor for the adjustment.)
Adjust the black level in accordance with the units and devices used.
When performing operations from a wireless
remote control
1. Press the <M/IRIS> button.
Set the iris to the manual mode.
2.
Press the <IRIS –> button.
The lens iris is stopped down.
3.
Press the <4> or <5> button to bring the cursor to
[Picture].
4. Press the <M> button.
The [Picture 2/8] screen is displayed.
P i c t u re 2/8
C h r o m a L e vel
C h r o m a P h ase
M a s t e r P e des tal
R P e d e s t al
G P e d e s t al
B P e d e s t al
P e d e s t a l Of fset
R e t u r n
5.
Press the <4> or <5> button to bring the cursor to
[Master Pedestal].
P i c t u re 2/8
C h r o m a L e vel
C h r o m a P h ase
M a s t e r P e des tal
R P e d e s t al
G P e d e s t al
B P e d e s t al
P e d e s t a l Of fset
R e t u r n
6.
Press the <M> button to start the [Master Pedestal] value
blinking.
7.
Press the <4> or <5> button, change the [Master
Pedestal] value, and press the <M> button to enter the
selection.
Adjust the value so that it matches the black level.
The pedestal values can be adjusted finely using the [R Pedestal],
[G Pedestal] and [B Pedestal] settings. (→ page 47, page 104)
8.
Press and hold the <MENU> button for about 2 seconds.
The camera menu display is exited.
9.
If necessary, press the <A/IRIS> button to adjust the iris
automatically.
When performing operations from a controller
When using an AW‑RP150
For details, refer to the operating instructions for the controller.
0%
0
0
0
0
0
Off
0%
0
0
0
0
0
Off
39