Advertisement
... print your plane | www.3DLabPrint.com
10. Pilots Please Attention!
For the first flights we recommend to increase expo settings on your transmitter for elevator
and aileron to 70 % (this calms the response from your stick inputs) and you can decrease
elevator, rudder and ailerons deflection to .
Make sure the battery is well fixed in proper position. If it moves during flight it will cause the
CoG move aft and can lead to uncontrollable flight behavior.
Once you become
experienced, you can increase the control surface deflections up to the
maximum of 60°+ and move the CoG a bit
backwards.
Standard CoG is 104mm /4.09in
from the Leading Edge of the wing (exactly the carbon tube position). Plane tuned like this is
capable of flying all elements of
extreme 3D
aerobatics.
NOTE: do not use full deflection at high speed (above Va speed) especialy ailerons, and of
course you can use your own values to your liking.
PLEASE MAKE PRE-FLIGHT CHECK motor mount, screws, ailerons, Rudder and Elevator
linkage before each flight (use Loctite), this is not a Toy...
Do NOT leave this PLA plane on direct summer sun or in car. (max. PLA temp is about 60C)
Spend at leats 10 hours with RC flight simulator before you go out for the first time.
fligh video
Recommended:
Flite test: RC Planes for beginners
Never fly aft (out of recommended) positioned Center of gravity.
47
page
Advertisement
