Advertisement
7.1 Decals
Use our prepared PDF marking - Cut decals from thin advertisement foil or use any local
advertisement or graphic company. Apply it to your model by your choice. You can use also
use our prepared shapes/patern (PDF) and make own paint work. This aircraft can be painted
with any waterproof acrylic colours. Please use your favorite procedure there is too much
options that it is hard to recommend any exact solution.
8.1 Motor Setup installing
Important:
Use only annealed PLA for motormount. PLA printed parts without annealing can NOT
withstand the motor heat.
Ensure your ESC bec/sbec is strong enought for all servos, or use separate battery...
See video guide #8.1
You will need: 4x 3/40bolt+washer+M3 nut (locknut or Loctite)
High Performance Setup (recommended) or similar:
Motor:
Xpwr 30CC Motor v2
ESC:
MEZON 90-120 lite with full telemetry (JETI Duplex) or CC...
Battery:
2x ZIPPY Flightmax 2650mAh 6S1P 40C in serial (12s) or similar (weight 2x 421g)
+ XT 60 2in1 series adaptor
Propeller:
Mejzlik Propeller 20"x8" E-L or any good
ECO Setup (old school and clasic precision aerobatics) or similar:
Motor:
Turnigy Aerodrive SK3 - 6354-260KV Brushless Outrunner Motor or similar
ESC:
MEZON 120 lite or similar at leats 90A/8s
Battery:
2x 4000-5000/4s in serial (8s) (weight 2x 450-550g)
+ XT 90 2in1 series adaptor
Propeller:
Turnigy Type A Beech Wood 3-Blade Propeller 18x8
alternatively 2- blade 20x8
Important:
check motor mount and screws before each flight, don NOT use PLA motor mout without
annealing!!!
... print your plane | www.3DLabPrint.com
45
page
Advertisement
