Advertisement
5.2 Ailerons servos - option 1
Instal aileron servo (use hot wire) then install ailerons.
Option 1 - Thanks to rigid 3d construction we can finally offer this direct servo drive option.
You dont need additional linkage/pushrods/arms anymore. Simple use self-tapping screws
and included servo arm. This option allows rotation of up to 65 degrees and is aerodynamicaly
very clear. If you use a good quality standard size servos (18+kg) this solution is suitable for all
flying styles from beginner to 3D extreme experts.
Proceed the way shown in videoguide:
See video guide #5.2
You will need:
2x standard size servo
servo extension cables 300mm / 12 inch
1.5/12mm self tapping screws
any fire source and wire 1-1.5mm (hot wire)
... print your plane | www.3DLabPrint.com
or thicker
38
page
Advertisement
