Advertisement
Insert servo into slot, then prepare holes for four self-tapping screws with hot 1-1.5mm wire,
you can use any steel wire and any source of fire (firestarter, dremel and so on...) and screw
the four screws in. Center servo to its neutral position (user your RC system or servo tester):
Asemble the pushrod and ball-link, axle to axle lenght should be 96mm :
Atach pushrod to servo arm and aileron arm, set proper lenght and
threads, secure ailerons (the red part shown on the picture) with two self-tapping screws.
highly recommend to test the power and function of the ailerons, use your hands to load it,
do not worry to use abrupt power, it is better if something goes wrong
... print your plane | www.3DLabPrint.com
41
page
apply Loctite
to all nuts
now...:
We
Advertisement
