Advertisement
6.1 Landing gear
Glue LG fuselage housing, make 6 holes to the Carbon Fiber Landing Gear center parts and
use hot wire to make the same holes to the printed LG fuselage housing...
NOTE:
You can use fully printed LG legs, BUT for display purpose only, or you can reinforce this
with some inner wire..., in other cases use carbon LG.
Proceed the way shown in videoguide.
See video guide #6.1
You will need:
Carbon Fiber Landing Gear 170mm
Lightweight Wheel 90-120mm (2pc)
40mm Tail Wheel or printed one
4mm Steel Axles w/M5 Thread
Hex locknuts M5
Landing Gear Wheel Stop Set Collar 9x4.1mm
Landing Gear Wheel Stop Set Collar 6x2.1mm
6x 3.5/20mm (4/25mm) self tapping screw
2 mm wire for tail wheel suspension
dremel or any drilling-machine
pliers
any fire source or hot tool (hot wire)
LG housing
99g/3.49oz
... print your plane | www.3DLabPrint.com
or any similar
or any similar
or any similar
or any similar
+ washers or any similar
tail wheel suspension patern
42
page
or any similar
or any similar
Advertisement
