Advertisement
Proceed the way shown in videoguide (this pictures will help you):
See video guide #5.2
Insert servo into slot, then prepare holes for four self-tapping screws with hot 1-1.5mm wire,
you can use any steel wire and any source of fire (firestarter, dremel and so on...) then screw
the four screws in. Center servo to its neutral position (user your RC system or servo tester):
Now attach servos arm to aileron and prepare holes for self-tapping screws with hot 1-1.5mm
wire, then screw this screws in. Note: you can use more screws, you know, feeling confident...:
Center servo to its neutral position (user your RC system or servo tester). Attach aileron to
axle of servo and again apply Loctite to servo arms bolts,then screw it in properly.
recommend to test the power and function of the ailerons, use your hands to load it, do not
worry use abrupt power, it is better if something goes wrong
... print your plane | www.3DLabPrint.com
now...:
39
page
We highly
Advertisement
