Sound Skip Check Result Display Mode - Sony MZ-N707 OpenMG Jukebox NOTES on installing & operating Service Manual

SOUND SKIP CHECK RESULT DISPLAY MODE

This set can display the count of errors that occurred during the
recording/playing for checking.
• Setting Method of Sound Skip Check Result Display
Mode
1. Set the test mode (see page 13).
[REC]
2. Press the key or
N
sound skip result display mode becomes active respectively
where the LCD displays the following.
Set LCD display
0 00
Total count of play
system errors (hex.)
3. When the N key is pressed, total error count is displayed on
the LCD, and each time the
item moves down by one as shown below. Also, if the
is pressed, the display item moves up by one, then if the
key is pressed, the display in the record mode appears.
[REC]
When the key is pressed, total error count is displayed
on the LCD, and each time the
item moves down by one as shown below. Also, if the
is pressed, the display item moves up by one, then if
the key is pressed, the display in the play mode appears.
N
Playing sound skip
result display
0 00
0 00
0 00
0 00
0 00
0 00
: Total play/record errors (hex.)
: Counter of sound skip check each item (hex.)
: 6-digit address where sound was skipped last (hex.)
key, and the playing or recording
Total count of record
system errors (hex.)
> key is pressed, the display
.
[REC]
key is pressed, the display
>
.
Recording sound skip
result display
0 00
0 00
0 00
0 00
0 00
• Cause of Sound Skip Error
Cause of error
EIB
Stat
Play
Adrs
BEmp
BOvr
Record
Bful
Rtry
4. To quit the sound skip check result display mode and to return
to the test mode (display check mode), press the
• Setting Method of Key Check Mode
1. Set the test mode (see page 13).
[T MARK]
2. Press the
key
Set LCD display
0 04
key
: AD value of the remote commander key
(hexadecimal 00 to FF)
3. When each key on the set and on remote commander is pressed,
its name is displayed on the remote commander LCD. (The
operated position is displayed for 4 seconds after the slide
switch is operated. If any other key is pressed during this dis-
play, the remote commander LCD switches to its name dis-
play)
Example1: When the
Set LCD display
0 04
: AD value of the remote commander key
(hexadecimal 00 to FF)
Example2: When the
is pressed:
Set LCD display
0 04
: AD value of the remote commander key
(hexadecimal 00 to FF)
MZ-N707
Description of error
Sound error correction error
Decoder status error
Address access error
Buffer is empty
Buffer is full, and sounds were
dumped
Buffer capacity becomes less,
and forcible writing occurred
Retry times over
x
key activates the key check mode.
key on the set is pressed:
>
key on the remote commander
N >
/ key.
CHG
17