Synchronize Remote Control; Check Operation; Adjust Aeration (If Necessary) - Valor Madrona MF28JN Installation & Owner's Manual

Synchronize Remote Control

The receiver and the handset of the remote control
system must be initially synchronized before the fi rst
use.
1. With a thin object, press and hold the receiver's reset
button until you hear one short and one long beep.
Release the button after the second beep.

Check Operation

Turn the fi replace fl ame up and down using the
remote control to confi rm that the full range of inputs
is achieved—see the remote control operation
instructions starting on page 8.

Adjust Aeration (if necessary)

Light the fi re and allow the unit to warm up for 10–15
minutes to evaluate the fl ame picture. The burner
is equipped with an adjustable shutter to control
primary aeration. See the fi gures below. The shutter is
factory-set to an aeration gap which will give optimum
performance for the vast majority of installations.
Air Shutter
Air Shutter
Slider & Cover
(natural gas)
Installation
Natural gas
Close
Open
Air Shutter Slider
Close
(propane gas)
Open
2. Within the subsequent 20 seconds, press the small
fl ame button ( ) on the remote handset until you hear
two short beeps confi rming the synchronization is
set.
This is a one time setting only and is not required when
changing the batteries in the remote handset. The
remote control system is now ready to use.
Depending of fuel bed used, altitude and other
considerations, the fl ame picture may be improved by
adjusting the aeration. The need for adjustment should
be determined only by operating the appliance with the
fuel bed and window installed and evaluating the fl ame
picture after a 15-minute warm-up.
Increasing aeration will cause the fl ames to appear
more transparent and blue making the ceramic logs
glow more.
Decreasing aeration will cause the fl ames to appear
more yellow or orange making the ceramic logs glow less.
Too little aeration may result in black carbon
forming and dropping into the fi rebox.
Propane gas
Flashback shield
(propane only)
Close
Open
QUALIFIED
INSTALLER
41