Remove Window; Unpack Casing; Reposition Lighting Instructions Plate; Unclip Remote Control Receiver - Valor Madrona MF28JN Installation & Owner's Manual

Remove Window

It is easier the remove the window and all the items
packed inside of the fi rebox to make the engine lighter
for installation.
1. Release the spring bolts at top and bottom of the
window by pushing and turning 1/4 turn.
x 4
2. Lift the window and set it aside in a safe place to
avoid damage.
3. Remove the log pack from inside the fi rebox and
set it aside with the window. Please handle the logs
carefully as they are made of fragile material and
can easily be damaged.

Unpack Casing

1. Rough-in the gas line and electrical wiring for a fan
(if any).
2. Decide where the stove should be positioned to
avoid moving it once all the casing is put together.
3. Unpack the casing and follow the instructions
supplied with each model (MFCS01, MFCS02 or
MFCS05).

Reposition Lighting Instructions Plate

Traditional arched or square stoves MFCS01,
MFCS02: The lighting instructions plate is attached to
the back of the engine and may have slid out of its slot.
Reposition the plate if this is the case.
Madrona Modern stoves MFCS05: The lighting
instructions is rolled and tucked in at the rear above the
angled fl ange or fan (if installed). Reposition the plate if
it has fallen out.
Installation

Unclip Remote Control Receiver

Under the engine,
the receiver box
is clipped
to the burner
pipes to facilitate
transportation.
Unclip the box
and let it hang
while you fi t the
gas pipe.
Fit Gas Pipe & Connector
Fit the pipe and connector supplied with the engine to
the valve. Connect the gas line to the inlet pipe.
3/8" gas line
connection

Replace Receiver into Position

Once the gas pipe is fi tted, clip the receiver on top of
the casting crossbar on the base, to the left hand side
of the valve. Make sure the receiver box is oriented
with its wires towards the back and its Reset button at
the front.
Receiver & clip
Receiver clipped to crossbar in fi nal position
QUALIFIED
INSTALLER
Receiver hooked to burner pipes
5/16" fl are
29