Replacing Batteries; Using Handset Wall Holder - Valor Madrona MF28JN Installation & Owner's Manual

Direct vent gas free standing engine
Hide thumbs Also See for Madrona MF28JN:
Table of Contents

Advertisement

OWNER'S
INFORMATION

Replacing Batteries

WARNING
!
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the fi replace cool fi rst before touching it.
CAUTION
DO NOT USE a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
Low battery signal: see page 11.
BEFORE changing the batteries, disconnect the
battery holder from the receiver.
The appliance uses four 1.5 V AA alkaline batteries
for its battery holder and one 9 V alkaline battery for
its handset. Batteries should last one to two seasons,
depending on usage. Removing the batteries in the off -
season will extend the battery life. Should the batteries
lose power, the control may be operated by manually
turning the control knob at the valve or by turning off
the valve at the switch.
To replace the batteries in the battery holder:
1. The battery holder is located underneath the fi rebox
behind the front trim. Open the bottom panel. Grab
the battery holder and pull it out from its location.
Battery holder
18
Servicing & Maintenance
2. Disconnect the battery holder.
3. Replace the batteries with 4 AA alkaline batteries.
4. Reconnect the battery holder.
5. Put the battery holder back in its position.
6. Close the bottom panel.

Using Handset Wall Holder

Your fi replace equipment includes a wall
holder to store the handset. If it hasn't
been installed, refer to the instructions
further on in this manual for the
installation.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Madrona mf28jp

Table of Contents