Valor Madrona MF28JN Installation & Owner's Manual page 16

OWNER'S
INFORMATION
To refi t the window:
DANGER
!
The window unit must be correctly installed,
fastened and sealed after servicing or serious
bodily injury and/or damage to the appliance
may result.
To ensure a safe operation:
• Double-check that the window frame is
correctly installed;
• Verify that the spring-loaded bolts are hooked
properly to the window tabs then;
• Pull out the top, then bottom of the window
and release it to insure the springs return it;
• Ensure the window is sealed before operation.
WARNING
!
Failure to install the window correctly can
leak carbon monoxide, aff ect the performance
of the fi replace, damage components, cause
overheating resulting in dangerous conditions.
Damage caused by incorrect window installa-
tion is not covered by the Valor warranty.
1. Place it on its frame and hold it in place while
pushing and turning its fastening studs 90 degrees.
2. Pull out the top and bottom of the window and
release it to insure the springs return it.
x 4
16
Servicing & Maintenance
3. Apply fi rm hand pressure around the window frame
to ensure the window is sealed tight against the
fi rebox.
4. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
Hot Glass Warning Plate
FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the stove front after
maintenance.
5. Re-install the front with barrier screen.
F O R S A F E T Y P U R P O S E , ensure the
barrier screen is re-installed on the fi replace
front after maintenance.
a) Traditional square stoves MFCS01, MFCS02
b) Traditional arched stoves MFCS01 and
WARNING
!
WARNING
!
and Madrona Modern stoves MFCS05: Re-
hook the cast front with barrier screen.
MFCS02: Re-install the barrier screen by
inserting fi rst the top clip in the arch of the front
and then pushing on the side of the screen so
that the clips snap into place.