Displays; Standard Settings - Wolf BWL-1S-05 Installation And Operating Instructions Manual

24.3 Displays

In the AM "Displays" submenu, the following real-time statuses and measured values, as well as statistical system
data, can be retrieved. Values are displayed according to system type and configuration.
Designation
T_boiler
T_boiler set
System pressure
T_outside
T_return
T_return, set
T_DHW
T_header
T_header, set
E1
Fan speed
ZHP speed
Electric heater status
Add HG status
AWO T_boiler
T_refrigerant (ICT)
Heating circuit flow rate
Power consumption
Heating output
Cooling capacity
Compressor frequency
T_evaporator
T_condenser
T_hot gas
T_supply air
Htg energy amount
DHW energy amount
Coolg energy amount
Compressor hrs run
Hrs run, boost. htr
No. of compr starts
PV status
Smart grid status
HCM-3 firmware
24.4 Standard settings
In the "Standard settings" submenu of the AM, the following standard system settings can be configured.
Night mode → AM FW1.70 → contractor parameter WP066
3064298_201805
AM display module
Unit Meaning
°C Flow temperature
°C Flow temperature (set value)
bar Secondary pressure/heating circuit pressure
°C Outside temperature
°C Return temperature
°C Return temperature (set value)
°C DHW cylinder temperature
°C Header/separating/buffer cylinder temperature
°C Header/separating/buffer cylinder temperature (set value)
E1 input status
rpm Fan speed (rpm)
% PWM activation of the feed/heating circuit pump (ZHP)
Electric heater status
Status of additional heat generator
°C Flow temperature (AWO/EWO board temperature sensor)
°C Refrigerant temperature (via AWO/EWO board pressure sensor)
l/min Heating circuit flow rate
kW Electrical power consumption
kW Thermal output in heating/DHW mode
kW Thermal output in cooling mode
Hz Compressor speed (rps)
°C Evaporator temperature
°C Condenser temperature (AWO/EWO board temperature sensor)
°C Hot gas temperature
°C Supply air temperature
kWh Amount of thermal energy in heating mode
kWh Amount of thermal energy in DHW mode
kWh Amount of thermal energy in cooling mode
hrs No. of compressor hours run
hrs No. of electric heater hours run
pce No. of compressor starts
PV input status (PV increase)
SG inputs status (Smart Grid function)
HCM-3 PCB software version
Designation
Language
Key lock
DHW op mode
DHW quick htg
Active cooling
Setting range
German, ...
OFF, ON
ECO, Comfort
OFF, ON
OFF, ON
OFF, ON
Factory setting
German
OFF
ECO
OFF
OFF
ON
53