Wolf BWL-1S-05 Installation And Operating Instructions Manual page 46

Connecting the HCP (230 V AC; max. 1.5 A) *
Push connecting cable through cable entry.
Connect the cable to terminals L1, N and
* Max. 1.5 A / 345 VA per output; sum of all outputs no
more than 600 VA
Connection, 3-way diverter valve, heating/cooling
(230 V AC; max. 1.5 A) *
Push connecting cable through cable entry.
Connect the cable to terminals L1, N and
* Max. 1.5 A / 345 VA per output; sum of all outputs no
more than 600 VA
Connecting output A1 (230 V AC; max. 1.5 A) *
Push connecting cable through cable entry.
Connect the cable to terminals L1, N and
* Max. 1.5 A / 345 VA per output; sum of all outputs no
more than 600 VA
Changing a fuse
Isolate the heating appliance from the power supply prior
to changing a fuse.
The ON/OFF switch on the appliance does not provide
isolation from the power supply.
The F1 and F2 fuses are located on the PCB (HCM-3).
F1: fine wire fuse (5x20 mm) 4 A (medium)
F2: micro fuse 1.25 A (slow)
Danger through 'live' electrical components. Never touch
electrical components or contacts if the heating appliance
has not been isolated from the power supply. Danger to life!
46
Indoor module electrical connection
.
.
.
Z1
Netz
L1
L1 L1
Figure: HCP connection
Netz Z1
L1
L1 L1
Fig: 3-way diverter valve connection
Z1
Netz
L1
L1 L1
Figure: Output A1 connection
F1
Netz
Figure: Fuse change
HKP A1
3WV
N
L1 N L1
3
HKP A1
3WV
N
L1 N L1
3
HKP A1
3WV
N
L1 N L1
3
F2
Z1 HKP
3064298_201805
3WV