Changes To Tlsv1.1 Configuration Property As Of Ilom 4.0.3.X; Changes To Tlsv1.1 Configuration Property As Of Ilom 4.0.3 - Oracle Sun Fire X4470 Product Notes

To verify that the server firmware version is a minimum of 4.0.4.20 or higher:
1. Use Oracle ILOM to check your system firmware version.
■ From the web interface, click System Information > Summary, then view the
System Firmware Version in the General Information table.
From the CLI, type:
■
For more details, refer to information about viewing system information and inventory
in the Oracle ILOM Administrators Guide for Configuration and Maintenance, which is
available at https://www.oracle.com/goto/ilom/docs.
Ensure that the server firmware version is at the minimum required version,
2.
shown above, or a subsequent release, if available.
If the required firmware (or newer) is not installed:
3.
a.
Download the firmware from My Oracle Support at:
com
For more information, see:
b. Install the downloaded firmware.
Refer to the information about performing firmware updates in the Oracle ILOM
Administrators Guide for Configuration and Maintenance, which is available at
//www.oracle.com/goto/ilom/docs. Ensure that you perform the preparatory steps
described in that document before updating the firmware.
Note -
display the power state correctly on the power control page. To correct this problem, clear your
browser cache before logging in to the Oracle ILOM web interface.
Changes to TLSv1.1 Configuration Property as of ILOM
4.0.3.x
Important Operating Note
Present Behavior: The Oracle ILOM TLSv1.1 configuration property is Enabled by default.
show /System/Firmware
Occasionally after installing the firmware, the Oracle ILOM web interface cannot

Changes to TLSv1.1 Configuration Property as of ILOM 4.0.3.x

or
version
"Getting Firmware and Software Updates" on page 49
.
https://support.oracle.
https:
Sun Fire X4470 Product Notes 11