Configuring The Mlc 52 Using Ir; Configuring Using Ir Data Transfer - Extron electronics MediaLink MLC 52 IR User Manual

im Vertrieb von
Operation, cont'd
The protocol for this configuration port is as follows:
1
5
2.5 mm connector cable for the configuration port
See chapter 5, Serial Communication, for details about using the software to set up
the system, and downloading drivers.
4
5

Configuring the MLC 52 Using IR

The MLC 52 can be programmed/configured via IR by the following methods:
•
•

Configuring using IR data transfer

You can configure your MLC 52 by transferring button configuration data to it from
another configured MLC 52 via the two IR LEDs on the back panels of the MLCs.
With this method, you replicate (clone) the other MLC's configuration on your own
unit without the use of software or cables.
www.camboard.de
3-4 MLC 52 Series MediaLink Controller • Operation
CAMBOARD Electronics
•
9600 bits/second
•
8 data bits
•
1 stop bit
•
No parity
6
9
9-pin D Connection
Pin 2 Computer's RX line
Pin 3 Computer's TX line
Pin 5 Computer's signal ground
Volume adjustment buttons — (Standard MLC 52 IR and MLC 52 RS only)
These two buttons are used to adjust the volume of the projector up and
down.
If your A/V system does not require the volume up and down function (for
example, if the MLC is configured with the VC faceplate containing the
volume control knob), you can reprogram these buttons for input selection or
additional projector functions.
The volume buttons are pre-labeled for convenience. They can be changed to
other labels that are provided. See Replacing button labels in chapter 2,
Installation, for the procedure.
Volume control knob — (MLC 52 IR VC and MLC 52 RS VC only) The
volume control knob on the VC models enables you to adjust the volume of
the display device via the MPA power amplifier.
IR data transfer from another MLC 52 that has been configured
IR learning from your projector's remote control
Tel. 07131 911201
Fax 07131 911203
Tip
Ring
Sleeve (Gnd)
TRS Plug
Tip
Ring
Sleeve
ce-info@camboard.de