6, Common Problems And Solutions - JGaurora JGMAKER Magic User Manual

6, Common Problems and Solutions

Problems
item
description
Filament breaks
1 at the top of
extruder mouth
Filament slips in
2
extruder
Temperature is
3
incorrect.
Model is
4
malformed
Model is
5
warped
G-code
6 generation
failed
Software
7 Installation
failed
SD card can't
8
read
Note：if no clear about the cause of malfunction， please contact our after sales for technique support.If printer be

cleaned
，should relevel the platform,avoid damage during second time printing
Reasons
A. Filament has run out .
B. Filament was exposed to moisture,
and has become brittle..
C. Filament was plugging the throat.
Filament is too thin, or has been
ground down by
extruder gear .
Temperature sensor is
malfunctioning.
Timing belts may be too
loose. Timing belt pulley
may be loose.
The print bed is not level
A、 Incorrect setting or wrong
B、 save path
OS may not be supported
A、 SD card not readed
B、 SD card broken
31
With User to Create Better Product
Solution
A. Replace filament before its gone
B. Store filament in air-tight container
when finished printing.Replace with fresh
filament spool.
C. Clean the throat. Refer to video on the
USB stick for instructions.
Retract filament and cut out the thin
filament section.
Contact support for advice or
replacement of temperature sensor .
Check and tighten the screw and belts.
Relevel print bed, and retry print.
Choose the correct machine type and
select the correct save path
Install only on compatible OS
A、 Take out SD card,turn off printer and
wait for 10 second, then turn on and
insect SD card
B、 Format SD card， and recopy model to
SD card