JGaurora JGMAKER Magic User Manual page 20

（3）Move axis：Move X\Y\Z\ axis.
【Move X】 ： The nozzle moves along the X axis， X+ is away from the original point， X- is close the original point；
【Move Y】 ： The hot bed moves along the Y axis， Y+is away from the original point， Y-is close the original point；
【Move Z】：The nozzle moves along the Z axis，Z+ is up，Z- is down；
【Extrude】：Load or Remove Filament by hand；
【Move 10\1\0.1mm】：Rotate Knot；
【移动 Y】：；
（4）Auto Home：Nozzle go back to original place.
【移动 Z】：；
【挤出机】：;
（5）Others：Disable steppers\change filament\Cooling
【Auto Home】：Nozzle and Hotbed go back to original place.
【Disable steppers】：after setted Auto Home and Move axis，the motor is
locked，when you need to move the nozzle and hotbed
by hand，please Disable Steppers first；
【change filament】：change filament now or after print；
【Cooling】：Cancel preheat；
19
With User to Create Better Product