Troubleshooting - Electrolux KDFEC40UX User Manual

11.6 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
The back lamp
The lamp glass cover is at
the back of the cavity.

12. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem
You cannot activate or op‐
erate the oven. The display
shows "400" and an acous‐
tic signal sounds.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The lamp does not oper‐
ate.
Steam and condensation
settle on the food and in
the cavity of the oven.
The display shows "12.00". There was a power cut.
1. Turn the lamp glass cover
2. Clean the glass cover.
3. Replace the oven lamp with a
4. Install the glass cover.
Possible cause
The oven is incorrectly
connected to an electrical
supply.
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The fuse is blown.
The lamp is defective.
You left the dish in the
oven for too long.
counterclockwise to remove it.
suitable 300 °C heat-resistant oven
lamp.
Use the same oven lamp type.
Remedy
Check if the oven is cor‐
rectly connected to the
electrical supply (refer to
the connection diagram if
available).
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
Reset the clock.
ENGLISH 23