Table of Contents
Advertisement
Basic Operation of the BLU300
HMI Setup Menu for the BLU300
The
menu allows you to change many of the hardware settings of the BLU300 OIT:
HMI SETUP
*
Most of the following settings can be changed through the Tools...HMI default settings. See
page 53 for more information on HMI Default Settings. Adjusting these settings from the local
setup menu is only provided as a convenient method of changing the parameters without
downloading a new project file.
Changing the Com Port Settings
The Com port setting on the OIT allows you to change the OIT's communications parameters for the RS-232 and RS-485
ports without having to download a new project file from the BlueLeaf configuration software.
*
It is not necessary to adjust these settings in the local setup menu, since these settings are
automatically changed whenever you download a project from the BlueLeaf software into the
OIT. Adjusting these settings from the local setup menu is only provided as a convenient method
of changing the parameters without downloading a new project file.
4
To change these settings, perform the following:
1.
Access the
2.
Press the F4 key, or use the up/down arrow keys to move the blinking cursor to 4.HMI Setup.
Press the
3.
Use the up/down arrow keys to move the blinking cursor to 1.Com port. Press the
4.
There are three menu items:
• HMI protocol- used to change the OIT's id #. This id # must match the HMI Comm. Addr setting
found in the BlueLeaf configuration software Options...PC-HMI Comm Settings menu before any
upload/download of a project file can take place. When transferring a project from one OIT to another,
the id #'s must match also.
• RS232- used to change the communications parameters for the RS-232 port (see table below).
• RS485- used to change the communications parameters for the RS-485/RS-422 port (see table below).
5.
From the Com port menu, use the up/down arrow keys to move the blinking cursor to the target
selection: HMI protocol, RS-232, RS-485. Press the
6.
To change a parameter (such a Baud Rate), use the up/down arrow keys to move the blinking cursor to
the parameter, and then press the
pressing the
per instructions given in the beginning of this chapter.
LOCAL SETUP MENU
key.
ENTER
Parameter
Baud Rate
Data Bits
Parity
Stop Bit
ENTER
key.
ESC
Options
4800, 9600, 19200, 38400, 57600, 115200
8 Bit, 7 Bit
Even, Odd, None
1 Bit, 2 Bit
key.
ENTER
key. At any time, you can cancel changing the parameter by
51
key.
ENTER
1010-0300, Rev 02
Advertisement
Table of Contents
