ComAp InteliGen NTC Communications Manual page 103

Enter password
Password setting command. Password has to be set before adjusting of protected setpoint or
calling protected gen-set control command. Setting password command is not necessary
before every adjusting. Password is a number in range 0 to 65535 and is valid for all rest of
SMS.
p PPPP (or pPPPP)
Syntax:
p
PPPP...
#5:accesscode
Example:
Setting password before adjusting protected setpoint.
ok
Return code:
er_pass ...
Gen-set control
SMS command for invoking gen-set control command as Start, Stop, Fault reset etc.
c Y (or cY)
Syntax:
c
Y
#5:accesscode p
Example:
This SMS command invokes gen-set Start. Password setting is needed in
case of password protection was configured for gen-set commands.
ok
Return code:
er_pass
c?
c_er
er_old
Read Alarm list
Read actual Alarm list.
a
Syntax:
a
#5:accesscode
Example:
Request of actual Alarm list.
AL=(items of alarm list) ... comma separated items of Alarm list.
Return code:
Exclamation mark in front of Alarm list item indicates inverse record (still
active alarm).
Communication Guide, ©ComAp – March 2014
IGS-NT Communication Guide 03-2014.pdf
...
command
password
p 1234, w 8252 144
...
setting password was successful
setting password is not valid
...
command
...
type of operation
Y Type of operation Y Type of operation
1 Start 7
2 Stop 8
3 Horn Reset 9
4 Fault Reset 10
5 GCB ON 11
6 GCB OFF 12
1234, c1
...
gen-set command was accepted
...
valid password was not set before executing the
command
...
unknown gen-set command
...
gen-set command execution is not allowed in actual state
(e.g. attempt to start the gen-set in OFF mode).
...
command was read out from SMS during GSM modem
initialization – in this case command will not be served.
...
command
a
MCB ON
MCB OFF
GCB ON/OFF
MCB ON/OFF
Next Mode
Previous Mode
103