Cleaning The Nozzle And Brush; Storing Your Machine - Bissell PET STAIN ERASER 2003 Manual

Cleaning the Nozzle and Brush

For more tips on how to maintain your machine, visit support.BISSELL.com.
1.
The front nozzle of the
machine removes for easy
cleaning of dirt and debris.
Remove the Formula Tank
and locate the latch at the
top of the nozzle. Pull tab and
rotate back to separate from
machine.
4.
Ensure the machine is
OFF and set upright on a
countertop or flat surface.
Remove the Scrubbing Brush
by lifting the tab up and
pulling gently to release.

Storing Your Machine

For more helpful maintenance tips, check out support.BISSELL.com.
Before storing your machine, ensure Dirty Water Tank is empty. Machine should not be left on its side
with water in the Dirty Water Tank. Store your machine in a protected, dry area.
NOTICE
To reduce the risk of a leaking condition, do not store where freezing may occur. Damage to internal
components may result.
WARNING
before performing maintenance or troubleshooting.
8 BISSELL.com
2.
Rinse nozzle with clean
water and check spray nozzle
for dirt or debris.
5.
Rinse brush with clean
water and check brush for
debris. Once cleaned, insert
brush by aligning the top of
the brush into the machine and
snap into place. Ensure it is
secure before using.
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect from charger
click
click
3.
Replace the front nozzle
by hooking lower edge onto
machine and snapping into
place. Then place the Formula
Tank back on the machine.
Note: Ensure nozzle clicks into
place and that it's properly
installed prior to replacing
Formula Tank. If nozzle does
not click, then the seal isn't
made and will significantly
reduce suction.