Cleaning & Replacing The Brush Roll And Chamber - Bissell JETSCRUB PET 2526 Series Manual

Cleaning & Replacing the Brush Roll and Chamber
Go to BISSELL.ca/support for additional maintenance tips for your machine.
1. 2.
Grasp Brush Roll Nozzle on Pull Brush Roll out by
both sides and pull upward to grabbing the Brush Roll tab
remove. and pulling upward.
4. 5.
Let your Brush Roll and Replace Brush Roll by
Brush Roll Nozzle dry before inserting the Brush Roll end
reassembling. into the right side of the foot.
Then lock the pull tab into
place by pressing downward.
7.
Rotate the Nozzle back into
place until you hear a "click".
WARNING
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting.
10 BISSELL.ca
3.
Rinse your brush roll and
brush roll nozzle with warm
water. The nozzle Clean Out
tool can be used to remove
hair and debris. Note: These
parts are not dishwasher or
automatic washing machine
safe.
If your Brush Roll chamber is
dirty, clean with a rag or towel.
6.
Replace the Nozzle by first
lining up both tabs with the
edges of the foot.