Troubleshooting - Bissell PET STAIN ERASER 2003 Manual

Troubleshooting

Below are some of the issues you may run into. If you don't see the issue you're experiencing
below, visit support.BISSELL.com.
Problem Possible Cause
Formula Tank is not properly seated.
Dirty Water Tank plug is not sealed
properly.
Machine is Dirty Water Tank is full.
leaking
Machine is not level.
Formula Tank cap is not properly
threaded.
Charger plug/cord not connected.
Machine is not
powered or
underpowered
Not the correct charger.
Formula Tank is empty.
Pump not primed.
Reduced spray
Batteries weak/undercharged.
or no spray
Spray tip clogged.
Formula Tank not fully inserted.
Dirty Water Tank drain plug is loose.
Reduced
suction or Dirty Water Tank not properly installed.
no suction
Removable Nozzle improperly installed.
Other maintenance or service not included in the manual should be performed by an authorized service representative.
But wait, there's more!
Join us online for a complete guide to your new product, including
troubleshooting, product registration, parts and more.
REGISTER
10
Ensure tank is fully seated, see page 4.
Ensure tank plug is sealed properly, see page 5.
Empty tank. Machine should not be left on its side with
water in the tank.
Ensure machine is upright.
Ensure cap is properly threaded on tank. If issue does not
resolve, contact Consumer Care.
Make sure charger plug is completely plugged into wall
outlet and charging cord is completely plugged into port on
back of machine.
Use only the charger that comes with the machine.
Refill tank.
While the machine is turned ON, press Spray Trigger and
gently rock Pet Stain Eraser™ back and forth.
Recharge according to instructions.
Rinse tip with clean water.
Ensure tank is securely seated by removing and then
replacing.
Check plug for snug fit.
Snap tank into place.
Remove and reinstall nozzle.
Go to support.BISSELL.com.
INFO VIDEOS
©2019 BISSELL Inc. All rights reserved.
Printed in China. Part Number 162-1329 07/19 RevB
Remedies
PARTS SUPPORT