WilTec 61495 Operation Manual page 17

Adjusting carburetor
A wrong adjustment may cause damage to your unit. If the engine does not
run well after adjusting the carburetor, please contact the shop where you pur-
chased the pro
Idle adjustment screw (F17)
This is the screw to adjust the engine rotation when the throttle lever is set to
the
Maintenance before storing
1. Brushing off dirt form the machine check damage or stack of each part if you find
out abnormalities, repair them for the next use.
2. Extract fuel from the tank and loose the drain screw of the float cabin to extract
fuel, turn on the engine and leave it running until it stops naturally.
3. Remove the spark plug and put in 1-2cc of 2-cycle oil in the engine. Draw the
starter rope 2-3 times, set the plug back and stop it at the contraction position.
4. Apply anti-rust oil to the metal parts such as the throttle wire put the security
cover on the blade
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
duct.
lowest speed position. If you turn right (clock-
wise) the rotation increases and left (counter-
clockwise)
decreases. In case the blade continues to rotate
or engine stops when you return the throttle lever
completely to the original position, make a
readjustment.
(1) Idle adjustment screw
(2) High
(3) Low
and keep the machine indoor avoiding dampness.
Seite 36