WilTec 61495 Operation Manual page 11

Installing the nylon cutter (Option) (F7)
1. Set correctly the inner and the outer holder to the gear shaft.
2. Screws the attached bold (M8 Left) into the gear shaft and secure it with the span-
ner.
3. Screw the nylon cutter into the bolt by fixing the inner holder with the L-shaped bar
and tighten it manually. Keep bolts and washers to install the blade carefully.
(1) Gear Case
(2) Bolt
(3) Nylon cutter
(4) Nylon cord
6. Fuel
- Gasoline is very flammable. Avoid smoking or bringing any flame or
- Wipe up all spills before starting the engine.
- Make sure to stop the engine and allow it cool before refueling the unit.
- Keep open flames away from the area where fuel is handled or stored.
- Never use oil for 4-cycle engine use or water cooled 2-cycle engine. It can
cause spark plug fouling exhaust port blocking or piston ring sticking.
- Mixed fuels which have been left unused for a period of one month or more
may clog the carburetor result in the engine failing to operate properly. Put re-
mained fuel into an airtight container and keep it in the dark and cool room.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Mix a regular grade gasoline (leaded or unleaded) and a
quality-proven motor oil for air-cooled 2 cycle engines.
RECOMMENDED MIXING RATIO
GASOLINE 25 :OIL 1
Seite 30