WilTec 61495 Operation Manual page 14

Cutting operation
Metal blade usage
Nylon cutter usage
- Nylon cord consumes large power. Please note that the engine rotation
should be in
- Nylon cutter cut grass with the power of cord rotation. If you try to cut grass
for the length of cord at one 50% as large as when using metal blade. time
rotation speed
case of large resistance
tion speed higher and cut a
- If you try to cut grass by swinging the brush cutter in the reverse way (from
left to right) scraps fly in the direction away from the body, so you can avoid getting
your clothes dirty.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
- Always cut by guiding the head from your
right to left.
- A metal blade cut best up to the point 1/3
from the edge. Use that area for cutting
shrubs tough and thick weeds. For cutting
young grass you can use up to 2/3 from the
tip of blade.
- Adjust the engine speed according to the
cutting
at middle speed and cut shrubs or tough and
thick weeds at high speed.
(1) For boughs and trees
(2) For grass and weeds
(3) Direction of cutting
(4) Direction of rotation
Operating at low speed make it easier for
grass weeds or twigs to caught up in the
blades and also it mokes the shaft and clutch
wear down more quickly.
operation
becomes lower due to resistance and you cannot cut well. In
get the nylon cutter away from grass once make the rota-
small amount of grass at one time.
objects. Cutthe young grass
Seite 33