WilTec 61495 Operation Manual page 13

When restarting immediately after stopping the engine move the choke lever to the
open position.
Stopping the engine
1. Return the throttle lever to the idling position.
2. Push the engine switch button.
Equipping the shawl band (F12)
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
4. Set the throttle lever to the starting position.(F10)
(1) Idling
(2) Starting (1/3-1/2 open)
(3) Full throttle
When restarting immediately after stopping the en-
gine move the throttle lever to the idling position.
5. While holding the unit firmly pull out the starter
rope quickly.(F11)
6. After the engine has started open the choke
gradually.
7. Allow the engine to run for 2 to 3 minutes to
warm up.
1. Equip the attached shawl band.(F12)
2. Turn on the engine return the throttle lever to
the lowest speed position and put the shawl band
hook to the hanging part of the machine.
3. Adjust the length of the shawl band so that the
blade may be parallel to the ground in the work-
ing position. In order to prevent stack during op-
eration turn up the extra part of the band from the
buckle.
Seite 32