BLADEZ 9.9T Owner's Manual page 8

ASSEMBLY INSTRUCTIONS CONTINUED
We strongly recommend using two people to ease the treadmill assembly.
NOTE: Make sure the power cord is unplugged before you begin assembly.
1. Tie the Lower Control Wire of the Frame
(B) with the Guide Thread of the Right
Upright (D). Pull the wire into the
Upright and secure with wire clip, then
insert into the Upright.
2. After the above step is finished, place the
Uprights (C, D) onto the Frame then
tighten with Allen Bolt(a)(refer to the
right drawing).
NOTE: When you assemble the Upright, one person
should hold the Upright to prevent it from falling.
3. To assemble the Computer:
Thread the Control Wire out of the
Upright (D) and connect it to the
Control Wire in the Handrail, then
secure the Computer Shelf with Allen
Bolt (b).
When assembling, make sure the holes on the
Handrails and Computer shelf are aligned.
If equipped with handrail switches, make sure
to identify that the left switches are used for
angle adjustment and the right ones for speed
adjustment.
BladeZ Corporation • 20155 Ellipse • Foothill Ranch • CA • 92610
C
a
a
b
7
www.ebladez.com
D
a
B
a
A
b
D