Turn On The Water Heater; Decommisioning; Turn Off The Water Heater - A.O. Smith TWI 35-200 Installation, User And Service Manual

c
8.9.5
8.10
8.10.1
52
Caution
When the CO value is not correct, refer to General errors (see 12.1.1), CO
2
value (at full load) is not correct.
Do not use the water heater when the CO
caused by the restrictor, venturi, venting system or gas category:
• Switch off the appliance.
• Turn off the gas supply.
• Put the cover back on the water heater.
• Contact your supplier.
8. If necessary, use a hex driver to adjust the adjuster screw until the CO
correct.
a) Turn the screw anticlockwise for a higher CO
b) Turn the screw clockwise for a lower CO
9. If applicable, set the temperature value back to the original value.
10. Set the control switch on the front of the water heater to 0 to turn off the water
heater.
11. Remove the measurement probe of the CO
cap (1) back on the nipple (2).
12. Shut off the gas supply.
Fig. CO value
2
2

Turn on the water heater

Refer to the procedure in the user part to Turn on the water heater (see 4.1).

Decommisioning

To decommission the water heater:
1. Turn off the water heater (see 8.10.1)
2. Drain the water heater (see 8.10.2)

Turn off the water heater

Refer to the procedure in the user part to Turn off the water heater (see 4.2) and isolate
the water heater from the mains power supply.
value is not correct and this is not
2
value.
2
value.
2
meter from the test nipple and place the
2
1. Cap
2. Test nipple
1
Installation, Maintenance and Service part
2
value is
2