Groen FPC Operator's Manual

Stainless steel manual tilting electrically heated braising pans

Advertisement

P IMPORTANT INFORMATION P KEEP FOR OPERATOR P IMPORTANT INFORMATION P
OPERATOR MANUAL
MODELS:
FPC, MW/FPC,
FPC/1, MW/FPC/1
Braising Pans
Stainless Steel
Manual Tilting
Electrically Heated
THIS MANUAL MUST BE RETAINED FOR FUTURE REFERENCE. READ,
UNDERSTAND AND FOLLOW THE INSTRUCTIONS AND WARNINGS CONTAINED IN
THIS MANUAL.
DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND
LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.
.
Model FPC/1-4
WARNING
OM-FPC
DOMESTIC
Part Number 121024
Model MW/FPC-4

Advertisement

Table of Contents
loading

Summary of Contents for Groen FPC

  • Page 1 P IMPORTANT INFORMATION P KEEP FOR OPERATOR P IMPORTANT INFORMATION P OPERATOR MANUAL OM-FPC DOMESTIC Part Number 121024 MODELS: FPC, MW/FPC, FPC/1, MW/FPC/1 Braising Pans Stainless Steel Manual Tilting Electrically Heated Model MW/FPC-4 Model FPC/1-4 THIS MANUAL MUST BE RETAINED FOR FUTURE REFERENCE. READ, UNDERSTAND AND FOLLOW THE INSTRUCTIONS AND WARNINGS CONTAINED IN THIS MANUAL.
  • Page 2: Important Operator Warnings

    FORWARD SUDDENLY DURING TILTING AND CAUSE HOT LIQUID TO SPLASH OUT. WARNING: USE OF ANY REPLACEMENT PARTS OTHER THAN THOSE SUPPLIED BY GROEN OR ITS AUTHORIZED DISTRIBUTORS VOIDSALL WARRANTIES AND MAY CAUSE BODILY INJURY OR EQUIPMENT DAMAGE. SERVICE PERFORMED BY OTHER THAN FACTORY AUTHORIZED PERSONNEL WILL VOID ALL WARRANTIES.
  • Page 3: Table Of Contents

    OM-FPC Table of Contents IMPORTANT OPERATOR WARNINGS ..........2 EQUIPMENT DESCRIPTION .
  • Page 4: Equipment Description

    OM-FPC Equipment Description The Groen FPC is a stainless steel, electrically heated This handwheel controlled mechanism is located in a Braising Pan which is equipped with integrated heating stainless steel console to right of the pan body. To elements, a hand operated tilting mechanism, facilitate cleaning, the pan body can be tilted past the electrical controls and a hinged cover.
  • Page 5: Installation

    OM-FPC Installation B. For Model FPC or FPC/1: WARNING THE BRAISING PAN MUST BE INSTALLED BY 1. Set the unit in place and level it by turning PERSONNEL WHO ARE QUALIFIED TO WORK the adjustable feet. Crank the pan body to a W I T H E L E C T R I C I T Y .
  • Page 6 GROUND THE UNIT at the proper terminal. such as Silastic. CAUTION ELECTRICALLY GROUND THE PAN AT THE TERMINAL PROVIDED. ELECTRICAL REQUIREMENTS Model FPC-2 or FPC/1-2 FPC-3 or FPC/1-3 FPC-4 or FPC/1-4 208 Volt 8.5 KW 11.5 KW 14.5 KW Single Phase...
  • Page 7: Initial Start-Up

    OM-FPC Initial Start-Up Now that the Braising Pan has been installed, you 4. Set the thermostat to 235 F. The heating should test it to ensure that it is operating correctly. indicator light should come on to show that the pan is heating. Heating should continue 1.
  • Page 8: Sequence Of Operation

    OM-FPC 4. To pour or dump product, remove grease, or WARNING assist cleaning, first raise the cover, then tilt IF THE PAN CONTAINS ITEMS IN SAUCE OR the pan up and forward by turning the MELTED FAT, THEY COULD SLIDE FORWARD handwheel clockwise.
  • Page 9: Cleaning

    OM-FPC Cleaning 1. Suggested Tools a. Cleaner, such as Klenzade HC-10 b. Brushes in good condition c. Cloth for cleaning controls CAUTION MOST CLEANERS ARE HARMFUL TO THE SKIN, d. Chlorine sanitizer such as Klenzade EYES, MUCOUS MEMBRANES, AND CLOTHING.
  • Page 10: Maintenance

    Maintenance WARNING USE OF REPLACEMENT PARTS OTHER THAN THOSE SUPPLIED BY GROEN OR THEIR AUTHORIZED DISTRIBUTORS CAN CAUSE INJURY TO THE OPERATOR AND DAMAGE TO THE EQUIPMENT AND WILL VOID ALL WARRANTIES. SERVICE PERFORMED BY OTHER THAN FACTORY-AUTHORIZED PERSONNEL WILL VOID ALL WARRANTIES.
  • Page 11: Troubleshooting

    Troubleshooting Your Groen Braising Pan will operate smoothly and efficiently if properly maintained. However, the following is a list of checks to make in the event of a problem. If the actions suggested do not solve the problem, call your authorized Groen Service Representative.
  • Page 12 OM-FPC Parts List...
  • Page 13: Parts Lists

    OM-FPC Parts List Description Part No. Description Part No. Gear Carrier Assembly (Casting) 014079 Nut - Acorn 090567 Worm Gear Sector 003692 Spacer - Long 012733 90 deg. Alemite Grease Fitting 012195 Thermostat - Non-adjustable 012840 Fuse Bus - 3 Amp...
  • Page 14 Stud Weld ¼” - 20x 012590 Cover Hinge Bracket 013485 Cover Hinge Bracket 013485 Bracket Cover 013277 Bracket Cover 013277 Actuator #51 FPC/CFPC 014085 Actuator #51 CFPC/CHFP 014085 Hut Hex Dome 005471 Hut Hex Dome 005471 Bracket Cover Hinge 054876...
  • Page 15: Electrical Parts Chart

    OM-FPC Electrical Parts Chart CONTACTOR HEATER INDIC. TRANS- MODEL LIGHT FORMER FPC-2, MW/FPC-2, FPC/1-2, & MW/FPC/1-2 208V/1 ph 013368 012842 016028 NONE 240V/1 ph 013368 012842 016028 NONE 208V/3 ph 013368 012842 016028 NONE 240V/3 ph 013368 012842 016028 NONE...
  • Page 16: Diagrams & Schematics

    OM-FPC Diagrams & Schematics FPC/1-2, 208 and 240 Volts FPC-2 and FPC/1-2, 208 and 230/240 Volts Single Phase (Manufactured before January 1, 1985)
  • Page 17 OM-FPC Diagrams & Schematics, Continued FPC-1 and FPC/1-2 Models 208 and 230/240 Volts Three Phase (Manufactured before January 1, 1985) FPC/1-2 380/415 Volts...
  • Page 18 OM-FPC Diagrams & Schematics, Continued FPC/1-3, 208 and 240 Volts FPC-3 and FPC/1-3, 208 and 230/240 Volts Single Phase (Manufactured before January 1, 1985)
  • Page 19 OM-FPC Diagrams & Schematics, Continued FPC-3 and FPC/1-3, 208 and 230/240 Volts, Three Phase (Manufactured before January 1, 1985) FPC/1-3, 380/415 Volts...
  • Page 20 OM-FPC Diagrams & Schematics, Continued FPC/1-4, 208 and 240 Volts FPC-4 and FPC/1-4, 208 and 230/240 Volts Single Phase (Manufactured before January 1, 1985)
  • Page 21 OM-FPC Diagrams & Schematics, Continued FPC-4 and FPC/1-4, 208 and 230/240 Volts Three Phase (Manufactured before January 1, 1985) FPC/1-4, 480 Volts...
  • Page 22: Maintenance Log

    OM-FPC Service Log Model No. Purchased From Serial No. Location Date Purchased Date Installed Purchase Order No. For Service Call Date Maintenance Performed Performed by...
  • Page 23: Warranty

    Groen Foodservice Equipment ("Groen Equipment") has been skillfully manufactured, carefully inspected and packaged to meet rigid standards of excellence. Groen warrants its Equipment to be free from defects in material and workmanship for (12) twelve months with the following conditions and subject to the following limitations.
  • Page 24 OM-FPC (Revised 9/98) 1055 Mendell Davis Drive Jackson, MS 39212 Part Number 121024 Telephone 601 372-3903 FAX 601 373-9587...

This manual is also suitable for:

Mw/fpcFpc/1Mw/fpc/1

Table of Contents