Installation; Wiring - Honeywell V4297A Series Product Data

SOLENOID SAFETY SHUT-OFF VALVE

INSTALLATION

When Installing This Product...
1. Read these instructions carefully. Be sure to follow
warning information carefully.
2. Check the ratings given in the instructions and on the
product to make sure the product is suitable for your
application.
3. Installer must be a trained, experienced flame
safeguard control technician.
4. After installation is complete, check out product
operation as provided in these instructions.
WARNING
Explosion Hazard and Electrical Shock Hazard.
Can cause explosion, serious injury or death.
Turn off gas supply before beginning installation.
Disconnect power supply before beginning installation.
More than one disconnection may be involved.
Mounting
Refer to the Integrated Valve Train Installation Instructions,
form 66-1099, for instructions on mounting a V4297A in a
Honeywell Integrated Valve Train System. Refer to the
installation instructions packed with the Honeywell KTCPI001
Visual Position Indicator for mounting instructions of the
indicator.
65-0246—1

WIRING

1. Make sure all wiring agrees with all applicable local
codes, ordinances and regulations. An opening is
provided to accommodate rigid conduit or armored
cable for line voltage operation. See Fig. 12.
2. Check the power supply circuit to verify the voltage
and frequency are correct for the valve.
3. See Fig. 13 for typical V4297A wiring with the RM7800
Burner Controller. Follow the burner manufacturer
wiring diagram, when provided. Refer to the relay
module wiring diagram for specific wiring terminal
designations.
4. Make wiring connections at the electrical terminations
provided in the valve wiring compartment.
Fig. 12. Wiring compartment of V4297A SSOV.
V4297A
N
L
M16540
Fig. 13. Typical wiring diagram for V4297A SSOV.
6
GROUND
G
NEUTRAL
L2
LINE
VOLTAGE 4
120 Vac
MAIN VALVE
9
RM7800
(TYPICAL)