Mcd 500 Usb Option - Danfoss VLT MCD 500 Pocket Manual

MCD 500 USB Option

This is achieved using the MCD USB Module
(Cat. No: 175G9009).
MCD500
Notes
• A single USB Module is required for each MCD 500
• The USB Module acts as a physical interface when using PC based
Master software such as WinMaster V4.x or MCT 10
• Driver software must be installed before the USB Module can be
used (supplied with the module on CD-ROM).
• For more information on the MCD USB Module, refer to the
Installation Instructions (MI.17.Cx.02) located at www.danfoss.
com/drives
MCD
USB
Module
USB cable
Cat. No: 175G9009
PC
Danfoss Drives · DKDD.PB.551.A1.02 | 51