Explosions And Implosion Hazards; Overheating; Laser Safety Instructions; Recycling The Scanner - Kodak Point-of-Care CR 120 Hardware Manual

Explosions and Implosion Hazards

Overheating

Laser Safety Instructions

Recycling the Scanner

CAUTION
:
Do not operate the equipment in the presence of explosive
liquids, vapors, or gases. Do not plug in or turn on the system
if hazardous substances are detected in the environment. If
these substances are detected after the system has been turned
on, do not attempt to turn of the unit or unplug it. Evacuate and
ventilate the area before turning off the system.
Do not block the air circulation around the Scanner. Always maintain at least
6 inches (15 cm) clearance around the Scanner to prevent overheating and
damage to the system.
During normal operation, always keep the scanner enclosed in its protective
cover to prevent the outside area from being exposed to laser emission.
During normal operation, do not remove the cover. Only a qualified
technician may remove the cover to service this product.
In the European Union, this symbol indicates that when the
last user wishes to discard this product, it must be sent to
appropriate facilities for recovery and recycling.
Contact your local authorized representative or refer to
www.kodak.com/go/recycle for additional information on
the collection and recovery programs available for this
product.
6H8044
Safety and Regulatory Information
1-3