Troubleshooting - PRO BAUTEAM Easycutter Series Operating Manual

rePLacing the hOt Wire
before any work on the machine itself, pull the mains plug and read all the instructions. non-obser-
vance of the instructions below can cause electric shock, fire and or serious personal injuries.
1. Carefully remove any remaining old hot wire.
2. Hook the new hot wire to one of the springs and then under tension to the opposite
spring. Be careful not to bend or damage the new hot wire during installation.

trOuBLeShOOting

Should the cutter – especially after a long uninterrupted use – not get hot, the transformer
has to cool down for a short moment (the transformer is equipped with a thermo-protec-
tion). Before re-using the device the power plug has to be briefly pulled out in order to
restart the protection circuit.
cutting variantS
Straight cut
Mark the required dimensions on the polystyrene sheet. Lift bow in order to draw the mate-
rial to be cut underneath the cutting wire.
DiagOnaL cut
Mark the required step (height and length) on the polystyrene sheet. Lift bow in order to draw
the material to be cut underneath the cutting wire up to the marked length.
tWO-SteP cut
Lift bow in order to draw the material to be cut underneath the cutting wire up to the
beginning of the cut.
BeveL
Mark required cut on the polystyrene sheet. Lift bow in order to draw the material to be cut
underneath the cutting wire. Adjust material in such a way that the required cut will exactly
go along underneath the cutting wire.
cOncave cut
Mark required hollow groove on the polystyrene sheet. Lift bow in order to draw the materi-
al to be cut underneath the cutting wire up to the marked place.
1
2
15