PRO BAUTEAM Easycutter Series Operating Manual page 12

18. Remove the adjustment tools (e.g. screw wrenches) and keep the work area clean
before turning on the equipment.
19. Dust may be created during works, which may lead to skin, eye and/or respiratory
irritation. For this reason, wear appropriate protective clothing, gloves, safety shoes and
a safety mask. Wear safety goggles which correspond to ANSI requirements and offer
protection against flying particles both from the front as well as from the side.
20. Handle the equipment's moving parts with care. Tie your hair back and do not wear
any jewellery or loose clothing. Otherwise, it might get caught in moving equipment or
application tools.
21. During work, ensure that your grip and stance are balanced and stable. Do not work on
a ladder.
22. Look out for any signs of your body becoming fatigued and stop working if these signs
of fatigue occur.
23. You must not use the electric power tool if you are suffering from sleep deprivation or are
under the influence of alcohol, intoxicants or medication.
24. Do not allow adults to use the equipment if they have not read these instructions or
are unable to follow them.
25. Children and young people are not permitted to use the equipment and application
tools. Instruct children that they are not allowed to play with the objects mentioned above.
Keep these objects out of the reach of children.
uSe of the electric Power tool and the aPPlication toolS
26. Do not overload the equipment, and use the equipment and its application tools in
accordance with these instructions and their intended use. Otherwise, there may be risk
to health and life.
27. Before each use of the equipment, all protective devices, cable connections, accesso-
ries and application tools must be thoroughly checked for damage in order to ensure that
the equipment and its application tools are working properly, with all of their functions.
Perform the following steps:
27.1 For electric power tools with blades and attachments: Tighten any loose screws. For
electric power tools with a wire: Inspect the springs and the tension of the cutting wire.
Please note that the wire in particular is used under tension. A worn-out wire can sud-
denly break and cause serious injury. For this reason, always wear safety goggles!
27.2 Before each use, inspect the equipment for damages, cracks, deformation or notice-
able traces of wear and tear. Do not use the device if any of these are present.
27.3 Inspect the orientation and connections of the application tools and all moving parts,
as well as the cable, for breakages, strong traces of wear and tear, other impairments,
and any other circumstances which may affect operation. If these are present, do not use
the equipment and/or the application tools.
27.4 Worn-out protective devices or other faulty parts must be replaced, or professi-
onally repaired by an authorised workshop. Damaged or worn-out application tools
must not be repaired; they must be replaced.
27.5 If you have inspected and used the application tool, you should carry out the
test steps as described in the paragraph entitled "Initial operation" in order to iden-
tify possible undetected damages to the application tools during the test run. Keep
other people away during the test.
12