Adjusting The Function For Holding The Thread By Blowing Air Upward - JUKI PS-800-12080 Instruction Manual

4-20. Adjusting the function for holding the thread by blowing air upward

❶
❷
❸
Blow-up pipe ❶ blows air to blow up the thread end
trailing from the needle to bring it under disk presser
❷ at the beginning of sewing by controlling the sole-
noid valve of the electrical system.
Thread end is pushed by air between the disk press-
er and the pattern at the beginning of sewing. In the
case the thread end cannot be pushed due to the lo-
cation and direction of slits on the pattern, adjust the
blowing direction of the air to allow the thread end to
be pushed by air.
Launch the pattern creation software to operate and
process the pattern to be sewn.
On the screen that is displayed by clicking "Op-
eration processing" ❸ , click ❹ ("Enter I/O") and
change the "I/O" to 5.
Change the "Level" to "high" ("low" refers to "turning
OFF"). Click ❺ ("Delay"). Change the "Delay (msec)"
to 225.
❹
❺
– 31 –