JUKI PS-800-12080 Instruction Manual page 43

Classifica-
tion of pa- Parameter name
rameters
Limited speed for the
limited number of reverse
feed stitches
Platen set- Prohibition of sewing
ting during lifting of the clamp
Sequential order of pedal
operation
Operation method of ped-
al
Thread clamp starting
angle at the beginning of
sewing
Thread clamp ending
angle at the beginning of
sewing
Thread clamp starting
angle during thread trim-
ming
Thread clamp ending
angle during thread trim-
ming
Winding set- Winder status
ting
Winder speed (sti/min)
Winder time limit (s)
Scale factor Scale factor of high speed
of speed (%)
Scale factor of medi-
um-to-high speed (%)
Scale factor of medi-
um-to-low speed (%)
Scale factor of low speed
(%)
Reset set- Clamp lowering at the
ting time of resetting
Clamp lifting after manual
resetting
Origin retrieving method
Return-to-origin speed
(mm/min)
Extension shaft reset
speed (mm/s)
Output I/O setting before
resetting
Output I/O setting after
resetting
Standard
Range
value
100 to 1800 0
Provided / not provid- Provided
ed
Normal / special Normal
1STA/1STB/ 2ST
1STC/2ST/
3ST
1 to 990 1
1 to 990 1
1 to 990 950
1 to 990 50
Allowed / prohibited Allowed
100 to 4500 2200
1 to 63000 200
1 to 100 100
1 to 100 90
1 to 100 80
1 to 100 70
Provided / not provid- Not provid-
ed ed
Provided / not provid- Provided
ed
XY simultaneous / X XY simulta-
preference / Y prefer- neous
ence
100 to 20000 15000
1 to 2000 80
OUT1 to OUT6 / Not Not set
set
High level / low level High level
XY axes / X axis / Y X axis
axis / No
– 41 –
Meaning of parameter and comment
Prohibition of sewing during lifting of the
cassette clamp
Sequential order of pedal operation
Operating method of the foot switch dif-
fers with the mechanical structure (such
as "with / without self-lock")
Thread clamp ON angle at the begin-
ning of sewing
Thread clamp OFF angle at the begin-
ning of sewing
Thread clamp starting angle during
thread trimming
Thread clamp ending angle during
thread trimming
Bobbin winder
Default state
Bobbin winding speed
Time setting of bobbin winding
Main interface main shaft actual speed
= Setting speed * scale factor of high
speed
Refer to the above description
Refer to the above description
Refer to the above description
Cassette clamp comes down when
returning to origin
Cassette clamp goes up when returning
to origin by pressing the reset button
"xy simultaneous" means that the x and
y axes are simultaneously reset to their
origins. "x preference" means that the
x axis is firstly reset to the origin, and
"y preference" means that the y axis is
firstly reset to the origin.
x, y axes speed during resetting to the
origin
Returning speed of OP axis
Setting of IO before resetting
Setting of IO after resetting