JUKI PS-800-12080 Instruction Manual page 46

Classifica-
tion of pa- Parameter name
rameters
Cyclic machining time
(min)
Cyclic machining interval
(s)
Work ending position
RFID identification meth-
od
Interface style
Motion mode is started
before work
Jump mode during opera-
tion
Connection extension
screen
Reverse feed after the
main shaft stops
Voice prompt
Data saving function en-
abled during power failure
File enabled upon sepa-
ration of electronic tag
Standard
Range
value
1 to 65535 1440
0 to 20 2
Return to 0 (zero) / Return to 0
sewing starting posi- (zero)
tion / default
Barcode / electronic Electronic
tag tag
Classic / simple Classic
XY simultaneous / XY simulta-
X precedence / Y neous
precedence
X precedence / Y X prece-
precedence / XY dence
simultaneous
Provided / not provid- Not provid-
ed ed
0 to 160 0
High / medium / low / OFF
OFF
Enable / disable Enable
Enable / disable Disable
– 44 –
Meaning of parameter and comment
Cyclic machining total time: When the
set time has elapsed, cyclic machining
is stopped
Interval from the completion of machin-
ing to re-starting of machining under the
cyclic machining mode
Return to 0 (zero): All of x / y axes
coordinates return to 0 (zero); sewing
machine terminates sewing; reset point
Right side: Rightmost position within the
machining range
Sewing starting position: First sewing
point of the machining file
Default: The sewing machine stops after
the completion of machining
By serial number of file: Barcode identi-
fication mode
By file name: Electronic tag identifica-
tion mode
Classic: Button style of the virtual body
Simple: Flat button style
Jump travel mode
In the case of "Use", information on the
operation file can be displayed on the
external add-on display
"High", "medium" and "low" respectively
refer to the magnitude of sound
After re-energization of the sewing
machine, the sewing sequence carried
out before power failure is resumed to
continue sewing from that interrupted
sequence.