Making A Template - JUKI PS-800-12080 Instruction Manual

4-21. Making a template

(1) Machining a template
12080 type template of dimensions of the maximum sewing range
・ Material of template: PVC plate
・ Template thickness: 1.5 mm thick PVC plate
・ Adjust the template size according to the cloths and/or pattern to be sewn.
The size must not exceed the maximum dimensions of the relevant specifications.
・ Check complexity of the pattern to be sewn. Then, select the sewing slits from the range of 6 mm to 8 mm
according to the complexity of the pattern.
・ Locus of sewing slits on the template should be designed according to the pattern to be sewn or intended
machining.
・ Select the suitable pattern carving machine. The template must be machined by the qualified engineers
who have successfully finished the on-the-job training.
・ After the completion of machining upper and lower templates, deburr the templates and the top surface of
the template mounting plate.
Cloth cutting range in X direction 1096.5
X-direction sewing range 1200
Technical requirements
1. There is neither burrs nor acute edges at rims of the template.
2. Determine the slit width within the range of 6 to 10 mm according to
the pattern template. Normally, it is set to 8 mm.
3. The width of slits in the knife machining area must be at least 10 mm.
4. This figure only applies to the PS-800-12080 provided with sewing
area of "1200 x 800" and the knife.
Position to which an
electronic label is
attached
Cloth cutting
– 32 –
Milling path
Milling path