JUKI PS-800-12080 Instruction Manual page 45

Classifica-
tion of pa- Parameter name
rameters
Detection of bottom line
(s)
Open QEP2
Thread Thread trimmer main
breakage shaft rotating speed
setting (sti/min)
Delay of start of thread
trimmer (s)
Wiper operating time (s)
Wiper stop delay time (s)
Delay of thread clamp
start (s)
Thread trimming during
jump
Wiper function
Motor thread trimming
method
Motor thread trimming
stroke
Deferred tightening of
thread trimmer (mm/sec)
Return speed ratio
Thread slackening start
mode
Thread slackening angle
Step-by-step speed set-
ting of knife
Knife length, Step1
Knife speed (mm/sec),
Step 1
Knife speed (mm/sec),
Step 2
Energization Needle bar stops at upper
setting position during energiza-
tion
Automatic return of cas-
sette to its origin during
energization
Motor excitation during
motor energization
Presser foot lifting during
energization
Other set- Air-pressure detection
tings
Repetitive operation
Standard
Range
value
0.01-255.00 0.2
Provided / not provid- Not provid-
ed ed
10 to 2000 260
0.01 to 6.55 0.12
0.01 to 6.55 0.12
0.01 to 6.55 0.1
0.01 to 6.55 0
Provided / not provid- Provided
ed
Provided / not provid- Provided
ed
To-and-fro / single To-and-fro
time
1 to 100 25
1 to 350 1
10 to 100 100
Angle / delay Angle
0 to 999 850
Provided / not provid- Not provid-
ed ed
0 to 100000 0
0 to 100000 10
0 to 100000 10
Provided / not provid- Provided
ed
Provided / not provid- Not provid-
ed ed
Provided / not provid- Provided
ed
Provided / not provid- Provided
ed
Provided / not provid- Not provid-
ed ed
Provided / not provid- Not provid-
ed ed
– 43 –
Meaning of parameter and comment
Thread breakage handling is carried out
after the set time has elapsed after the
confirmation of thread breakage
Sewing machines, in part, measures the
b-encoder as bobbin thread.
Thread trimmer main shaft speed
Delay time at the start of thread trim-
ming
Wiper operating time
Wiper OFF delay time
Thread clamp ON delay time
Whether thread is trimmed at the time of
jump
Whether the wiper is used
Motor thread trimming mode
Motor thread trimming stroke
Thread take-up time of thread trimmer
Rotary knife speed ratio
Thread clamp OFF starting timing meth-
od
Thread clamp OFF angle
Whether the step-by-step projection
speed is used by knife
Length of knife projection by one step
Speed of knife projection by one step
Speed of knife projection by two steps
Needle bar is at upper position when
turning the power ON
Cassette automatically returns to its
origin when turning the power ON
Motor is excited when turning the power
ON
Presser foot goes up when turning the
power ON
In the case of "Enable", the sewing
machine stops and generates the alarm
if the detected air pressure is low during
work
"Enable" means that cyclic machining of
the same file is started after turning the
power ON