JUKI PS-800-12080 Instruction Manual page 44

Classifica-
tion of pa- Parameter name
rameters
Setting of Automatic thread trim-
stop ming at stop
Needle bar position at
stop
Crimp board rise at stop
Stop switch tap
Statistics Clearing of the bobbin
settings thread remaining length
when turning the power
ON
Stop of operation after the
bobbin thread has run out
Setting of the bobbin
thread counting
Clearing of the sewing
counter when turning the
power ON
Continuous operation
after the sewing counter
reaches the set value
Sewing counter function
Working hours
Bobbin thread counting
method
Surplus length of bobbin
thread (mm)
Thread Thread clamp position
clamp set- during thread trimming
ting
Thread clamp position at
the beginning of sewing
Detection Automatic detection of
of thread thread breakage
breakage
Neglect of detection of
thread breakage
Number of effective stitch-
es when thread breakage
is detected
Delay of handling of bro-
ken thread after detecting
thread breakage
Standard
Range
value
Provided / not provid- Provided
ed
Upper stop position / Upper stop
Lower stop position position
Provided / not provid- Provided
ed
Self lock / Normal Self lock
Provided / not provid- Not provid-
ed ed
Provided / not provid- Provided
ed
Provided / not provid- Provided
ed
Provided / not provid- Provided
ed
Provided / not provid- Provided
ed
Provided / not provid- Provided
ed
Provided / not provid- Provided
ed
IN1 to IN4 / default Default
0 to 600000 0
0 to 200 0
0 to 200 0
Provided / not provid- Provided
ed
Provided / not provid- Provided
ed
1 to 255 3
1 to 255 2
– 42 –
Meaning of parameter and comment
Whether the remaining amount of
bobbin thread is reset to 0 (zero) when
turning the power ON
In the case of "Enable", the sewing ma-
chine stops when the consumed bobbin
thread length has reached the "entire
length".
In the case of "Set", statistics automat-
ically indicate the consumed bobbin
thread length
Whether the sewing counter is reset to
0 (zero) when turning the power ON
Whether the operation is continued after
the sewing counter has reached the set
value
Whether the sewing counter is enabled
In the case of "Enable", the machining
time statistics function is enabled
Statics mode of the bobbin thread
amount
Adjustment of the bobbin thread remain-
ing amount
Thread clamp position during thread
trimming
Thread clamp position at the beginning
of sewing
Laser output
In the case of "Detect", the operation is
stopped and the description of error is
displayed.
Thread breakage detection function
In the case of "Detect", thread trimming
is automatically carried out after detec-
tion thread breakage
Thread breakage is followed by thread
trimming
For the number of stitches firstly set,
thread breakage will not be detected
In the case thread breakage is detect-
ed continuously to reach the specified
maximum number of broken stitches,
it is assumed that thread has broken
definitely.