Advertisement
MAINTENANCE
It is not necessary to remove the tyre from wheel rim
always to attend a puncture. Even though, if there is
need of tyre removal, it is strongly recommended to
use a tyre removal / fitment machine.
If at all, tyre levers needs to be used, the levers should
be free from sharp edges. Care should be taken not to
damage the tyres and rims.
Warning
The tyre inflation pressure in cold condition and the
tyre tread condition are extremely important for the
performance and safety of the rider. Check the tyres
frequently for inflation pressure as well as the wear
pattern on it. Use of a tyre other than the standard may
cause instability.
Caution
The side walls of the tubeless tyre which in contact
with the wheel rim are only seals the air inside the
wheel assembly. Hence care should be taken not to
damage the side walls of the tyres during removal /
reassembly.
FRONT WHEEL REMOVAL AND REASSEMBLY
1. Remove the axle nut (1) along with a washer.
2. Pull out the axle (2) along with a washer and take
out a spacer from the right side of the wheel.
3. Place a support below the foot board to prevent
the vehicle from falling and lift the vehicle up.
4. Dislocate the wheel assembly along with brake
the panel from front fork. Separate the brake panel
from the wheel and take out the wheel.
5. Reverse the procedure for reassembling. While
reassembling ensure to locate the lug on fork leg L
to the slot in the brake panel.
1
-41-
2
Hide quick links:
Advertisement
