TVS Jupiter Fi Owner's Manual page 40

MAINTENANCE
SELF - MAINTENANCE PROCEDURES
BATTERY
Battery is located at the front of Steering column and
covered by front panel. The front panel and rear panel
must be removed to access the battery. TVS Jupiter Fi
is fitted with a maintenance free battery. so it is not
required to fill the distilled water.
To ensure better performance and long from the
battery, you are requested to follow the steps given
below:
1. For cold starting use kickstarter.
2. Check the battery voltage in every service and
charge if the battery voltage is less than 12.4V
charge the battery using MF battery charger only
at TVS Motor Company Authorised Distributor or
Dealer / Authorised Service Centers.
3. Do not add additional electrical accessories.
4. While connecting the terminals, observe the
correct polarity. Connect the red wire to the ' + '
positive terminal and black wire to the ' - ' negative
terminal of the battery.
5. Apply petroleum jelly at terminals to prevent it
from corrosion.
FUSE
Non-working of electrical systems may be due to
safety fuse failure. Short circuit or overload in the
electrical system are the main cause for fuse failure.
Three fuses are used in the vehicle. 15A Main fuse,
10A fuse for Fi loads and 10A fuse for DC loads.
Main fuse is located at the left side of the battery
holder. The front panel must be removed to access
the main fuse. Follow the procedure given below for
inspecting and replacing the fuse.
-31-