Advertisement
MAINTENANCE
REAR WHEEL REMOVAL AND REASSEMBLY
1. Place the vehicle on the centre stand.
2. Hold the rear brake firmly and remove the wheel
mounting nut (A) along with a washer.
3. Slightly tilt the vehicle and take out the wheel from
the rear axle.
4. Reassemble the wheel in the reverse order of
removal.
Warning
Always make sure, whenever the wheel is removed,
the axle nuts are tightened properly to the specified
torque.
A
STORAGE PROCEDURES
For storage of your scooter for longer period of over
a month and above, we recommend to carry out the
following steps:
1. Clean the vehicle thoroughly. Park the vehicle on
centre stand.
2. Warm up the engine and drain engine oil and
transmission oil. Store the oil, if new, in a dust
free container.
3. Remove the spark plug and feed in several drops
of engine oil through spark plug hole. Crank the
engine few times and reinstall the spark plug.
4. Remove the battery, store it away from direct
sunlight and freezing temperatures.
Caution
Do not park the vehicle on a slope or soft ground or
else it may fall down. The exhaust system becomes
hot after a run. Park the vehicle in a place where
pedestrians or children are not likely to touch the
vehicle.
During storage, the battery must be recharged at
recommended charger if stored more than a month.
-42-
Hide quick links:
Advertisement
