TVS Jupiter Fi Owner's Manual page 24

KNOW YOUR TVS JUPITER FI
To release the rear brake lock, squeeze the rear brake
lever further in and the lock will release automatically,
then release the brake lever.
5. High/low beam cum pass by switch
The head lamp glows automatically along with the
position lamps, speedometer back illumination, tail
lamp and number plate lamp once the engine is
started. Only the head lamp beam (high/low) can be
controlled by pressing the high/low beam switch.
Press the towards ' ' to operate head lamp high
beam or press it towards '
low beam.
TVS Jupiter Fi has a combined switch for head lamp
'high/low' beam and pass by. To operate the pass by,
keep the switch in 'low beam' position, press gently
and release. This makes the head lamp high beam to
flash and signal the approaching vehicle. The pass by
signal can be used while overtaking during day time.
Warning
Use appropriate head lamp beam 'high/low' as per the
traffic and road conditions for your safety and to avoid
inconvenience to other riders. It is strongly
recommended to ride the vehicle in 'low' beam during
day.
' to operate head lamp
Note
Once the engine is started, the head lamp, position
lamps, speedometer back illumination, tail lamp and
number plate lamp glows automatically. Only
headlamp beam can be controlled using beam control
switch.
HANDLE BAR RIGHT SIDE
1. Front brake lever
The front and rear brake applied together while
squeezing the front brake lever gently towards the
throttle grip. The brake lamp glows on application of
front brake.
3
-15-
1
2